Panel Gauge Film Protector - Suzuki Burgman Street EX

Please read the product description carefully before placing an order. Product Details: Panel Gauge Thin Film Protector Inclusion: 1 PC. Film Protector For B1T1, same as customer’s preferred color or Clear/Smoke Fitment: Suzuki Burgman Street EX ( Also applicable to Suzuki Avenis) Made from High Quality Stickers Durable and Long Lasting Water resistant and Sunproof Scratch resistant Prevents Moisture Machine Cut Easy to install Protective Film - 3 plies thin laminated film. Made from polyethylene terephthalate (PET), a thermoplastic polymer resin, has clarity, tensile strength, dimensional stability, and ability to accept a variety of surface-applied. Installation Procedure: 1. Clean your motorcycle's panel gauge 2. Make sure that there is no dust or dirt on your panel before you install the sticker film. 3. The sticker film has three layers. The front cover, the back cover, and the one in the middle is the panel protector itself. 4. The front cover is much softer than the back cover. Back cover protects the sticky side so make sure that you put the sticker guide on the back cover (the harder sheet) 5. Two ways to install. A. Direct installation - slightly peel off the back cover from the corner and then attach directly to the gauge. make sure it’s perfectly placed before completely peeling off the full back cover of the film. after you place the film on the panel, use pvc card covered with fabric or squeegee to rub the surface of the panel to prevent bubbles. Remove the top protective layer of the film. B. Water process - remove the back cover (sticky side) entirely from the film, then spray water all over the sticky surface of the film, as well as on your motorcycle's panel gauge. Then carefully attach the film on the gauge. After it's perfectly placed, you can rub using pvc card covered with fabric or use a squeegee on the surface of the panel to remove the unwanted bubbles. Then, remove the top protective layer of the film. DONE. NOTE: This film protector is self-healing, bubbles that emerged during installation usually goes away on it's own after 1 week. *Do not use heat gun as it might damage the film protector or the panel gauge. THE SLLER IS NOT RESPONSIBLE FOR ANY FAULTY PROCEDURE DONE UPON INSTALLATION.