2in1 Panel Gauge Protector - Honda Click 125i 150i V2

Panel Gauge Protector Set ( Carbon Sticker & High Quality Film Protector Sticker) Fitment: Honda Click 125i 150i V2 * Made from High Quality Sticker * Durable and Long lasting * Waterproof and Weatherproof * Easy to Install * 100% protection covered all buttons and panel. * Machine Cut Available Carbon: ️3D - matte, waterproof, slightly thinner than 4D. ️4D - high definition matte with gloss effect, waterproof, thicker than 3D. Installation Procedure Gauge Panel Protector 1. Clean your motorcycle's panel gauge 2. Make sure that there is no dust or dirt on your panel before you install the sticker film. 3. The sticker film has three layers. The front cover, the back cover, and the one in the middle is the panel protector itself. 4. The front cover is much softer than the back cover. Back cover protects the sticky side so make sure that you put the sticker guide on the back cover (the harder sheet) 5. Two ways to install. A. Direct installation - slightly peel off the back cover from the corner and then attach directly to the gauge. make sure its perfectly placed before completely peeling off the full back cover of the film. after you place the film on the panel, get an atm card and cover it with fabric, then use it to rub the surface of the panel to prevent bubbles. B. Water process - remove the back cover (sticky side) entirely from the film, then spray water all over the sticky surface of the film, as well as on your motorcycle's panel gauge. Then carefully attach the film on the gauge. After it's perfectly placed, you can rub using atm covered with fabric or squeegee on the surface of the panel to remove the bubbles. After applying gauge film protector, proceed with the carbon installation. 1. Clean the motorcycle's panel. 2. Make sure that your panel is dry and has no dust or dirt before you install the carbon sticker. 3. Peel off the backing paper of the carbon sticker and carefully place the carbon sticker on the panel surface. 4. Use an atm card covered with cloth or squeegee to remove the unwanted bubbles. (Use Blower or Heat Gun for better installation result.) DONE.