50Pcs ceramic tile leveling machine ceramic tile gap micro-leveling wedge alignment for wall and floor tile construction

 

Wear-resistant, recyclable.

Easy to use in DIY operation.

Balance tiles in the same horizontal position.

Improve the installation speed of tile.

Reduce the fatigue/pressure of installers.

There is hardly any crackless, flat surface.

It reduces the need for grinding and polishing.

Prevent tiles from moving during solidification.

 

Use Tips:

Lay the first tile, leaving more than 2mm (with cross gaskets). Close to tile.

Insert T-pins along the gap between tiles.

Then rotate 180 degrees and the T-needle is stuck at the bottom of the two tiles.

Adjust the lid with a hand/special wrench until the two tiles are on the same level.

After leveling for about 5-6 hours, before the cement/adhesive is completely dried, rotate the lid in reverse and take out the 180 degree T needle until the word is removed.

 

Avoid not removing the T-tile leveling system:

1. Ceramic tile gaskets are 2mm or more (cross gaskets are recommended)

2. When leveling, the cement or tile adhesives around T-type leveller must be cleaned.

3. Remove the T-type straightener about 5-6 hours after leveling before the tile binder or cement is completely dried.

 

Package includes: 50pcs Floor tile leveler and 1pcs wrench