Product description
Product name: Microcomputer temperature controller
Supply voltage: 110V-220V
Temperature measurement range: -50~110
Temperature control range: -50~110
Temperature control accuracy: 0.2
Measurement input: NTC10K waterproof probe L=1 meter
output type: direct output
Installation hole distance: 73mm (diameter 4mm)
Appearance size: 60*45*31mm
1.Set the start temperature value: long press UP button the temperature display Flashing , press the UP or Down button Set the start temperature value
2.Set the stop temperature value:long press Down button the temperature display Flashing , press the UP or Down button Set the stop temperature value
•How to restore factory default settings?
When the power supply is connected, press and hold the up and down buttons for 3 seconds at the same time until the word 888 appears on the display.
If the digital Sreen display LLL, the sensor is out of order. Check the sensor or replace it.
If the digital Sreen display HHH, indicate that the detection temperature exceeds the measurement range, the service environment can be changed.
Incubation box, computer host, refrigerator, indoor temperature control, refrigerator, greenhouse cultivation, fermentation equipment, aquarium
Control the water heater, stop heating when it reaches 65C, and start again when the temperature drops to 50C. How to set it?
1. Set the start temperature < stop temperature to determine the heating mode.
2. Press and hold the up button, the temperature of the startup gear flashes, and set the startup temperature to 50C through the up and down buttons.
3. Press and hold the down button, the stop temperature flashes, and set the startup temperature to 65C through the up and down buttons.
1 * 220V LED Temperature Controller
1 * Thermostat Control Switch Probe
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.