Temperature thermostat Digital Temperature Controller Thermostat Thermoregulator incubator Relay LED 10A Heating Cooling STC-1000 STC 1000 110-220V Thermostat Sensor

Please set it to C when the high temperature starts in cooling mode

Low temperature startup is heating mode, please set it to H

P1 hysteresis setting

In heating mode (H): measured value ≤ set value - when the hysteresis starts, the output heats up to the set value and stops

In cooling mode (C): When the measured value ≥ set value + hysteresis, start output cooling until the set value stops

P2 maximum setting range: the maximum value does not exceed this value when setting the temperature

P3 minimum setting range: the minimum value is not lower than this value when setting the temperature

P4 temperature correction

When there is a deviation between the measured temperature and the standard temperature, this function can be used to correct, the corrected temperature = the temperature before correction + the corrected value

P5 delay start time unit: minute

When controlling the refrigeration of the compressor equipment, the delay time can be set according to the needs. When the controller outputs, the equipment will not start immediately, and it needs to run after the set delay time.

P6 high temperature alarm

When the measured value is greater than this value, the screen will display --- and beep alarm, and at the same time, the output will be forcibly disconnected

P7 data lock function

Turn on the data lock to keep the current setting unchanged. At this time, the set temperature and function are invalid. If you need to modify it, you need to turn off the data lock function

P8 factory reset

Long press SET to switch to P8, press SET once to set to on, press Rst to restore factory settings

You can also press and hold the +- key for power-on self-test and restore factory settings

Instructions for use

Please connect the power supply according to the parameters and circuit diagram, and connect the cooling or heating equipment to the output terminal

Enter the internal setting to select heating (enter P0 to select H) or cooling (enter P0 to select C) mode as needed

Set the temperature method: press Set once and the screen flashes, press up and down to set the desired temperature, press Rst to confirm and return

OUT indicator light on the panel: flickering means cooling or heating start delay, constant light means output