Ayos naman kaso nga lang hindi ko nakabit ng maayos mahirap kapag di ka professional na magkabit ng ganito
December 15, 2023
𝙸**
Item: Black
Makapit sya at makapal. Solid 🔥🔥
January 9, 2024
L** ❣**
Item: Black
Sheeeesh angas 🥰
July 15, 2024
K**i
Item: Smoke
What you see is what you get very good product i will order again
August 24, 2024
R**⚓
Item: Chameleon black
The product gets 5 star rating from the customer
July 14, 2023
PRIME Motoparts
78 items
Shop performance
Better than 84% of other shops
Ships within 2 days
83%
Responds within 24 hours
79%
Product description
Click V2 V3 125i 150i kilay tint pair
Iwas bitak sa lens
Added porma
Need blower / heatgun para ma install
Ang bubbles hindi po sa item nasa nag iinstall
Installation Procedure
1. Clean your motorcycle's headlight
2. Make sure there is no wax, dust or dirt before you install the sticker film
3. The sticker film has three layers. the front cover, the back cover, and the one in the middle is the sticker itself.
4. The front cover is much softer than the back cover. Back cover protects the sticky side so make sure that you put the sticker guide on the back cover (the harder sheet)
5. you can do the installation in two ways:
A. Direct installation - slightly peel off the back cover from the corner and then attach directly to the headlight. Make sure its perfectly placed before completely peeling off the full back cover of the film. After you place the film on the panel, get an atm card and cover it with fabric, then use it to rub the surface to prevent bubbles.
B. Water process - remove the back cover (sticky side) entirely from the film, then spray water all over the sticky surface of the film, as well as on your motorcycle's headlight. Then carefully attach the film. after its perfectly placed, you can rub using atm covered with fabric to prevent bubbles. This process is more advisable to newbie