Fuse Add-a-circuit ATM APM Blade Car Fuse 12V Fuse Holder 10A 15A 20A 25A 30A(1piece)

1.Allows easy installation of additional circuits without cutting, splicing or soldering.Protect original circuit.

2. Simply remove an existing fuse from the fuse box, insert that fuse in to the bottom slot of the fuse tap.

3. These fuse holders turn 1 slot into 2 which allows individual protection for each circuit.

4. The holders are perfect for installing aftermarket accessories to vehicles along with many other uses.

Installation Instructions:

1. Disconnect power source

2. Select and remove a fuse in your vehicles fuse box with constant or switchable power capabilities that matches the power requirements of the accessory you are adding.

3. Insert new accessory fuse into added slot.

4. Install Add-A-Circuit with the newly added fuse installed, back into the fuse block. Reconnect power source. Turn on ignition to test new accessory for proper operation. If the accessory does not operate, turn the Add-A-Circuit 180 degrees and reinsert into the fuse block. Retest new accessory.

5. Replace the original fuse into the remaining slot on the Add-A-Circuit. Test both accessories for proper operation.

1. Simply remove an existing fuse from the fuse box, insert that fuse in to the bottom slot of the fuse tap.

2. Insert a suitable fuse for the new accessory in to the top slot.

3. Crimp your new live wire to the blue butt terminal on the fuse tap.

4. Insert the fuse tap into the fuse box slot where the fuse originally was.

Note:

1.Please allow a slight difference due to manual measurement.

2.This is a universal part we cannot tell you if it will work for you, please check first, Thank you