[Local shipment] 3800W 12V Car Audio Amplifier 2 Channel Powerful Low Pass Filter Bass Car Amplifier

 

Features:

- Vehicle power amplifier housing adopts standard safety interface to eliminate inferior accessories.

- The design of aluminum alloy cooling holes for vehicle power amplifiers has wider contact with air and faster heat dissipation.

- Two color coil transformer, small size and high power, reject all short circuit and improve the utilization rate of PCB board.

- Using high power non-sense resistance, good stability, support high temperature working.

- Powerful electric circulating coil ensures sufficient power when the power amplifier is in operation, and it is safer, more efficient and more stable when used.

- Can push 8-12 inch subwoofer (double voice coil speaker can also be)

- 3D surrounds you to immerse yourself in reality.

- When the circuit is shorted, the fuse will automatically disconnect and protective equipment.

- Black Diamond capacitors, sound and mellow, increase the musical expression of equipment, greatly enhance the overall sound effect.

- Peak 1000W High Power Amplifier Board

 

Model: C-236

Voltage: 12V

Maximum Power: 400W

Peak Power: 3800W

Place of Application: for Cars

Out Power: 3800W

Impedance: 4 - 8Ω

Material Type: Aluminum Alloy

Audio Sensitivity: 90dB

Number of Channels: 2

Frequency Response: 20Hz - 20KHz

Frequency Range (Hz): 87.5MHz - 108.0MHz

1.MAX Power Rating :

4 ohms: 1200 watts x 2 chan

2 ohms: 1900 watts x 2 chan

2.RMS Power Rating:

4 ohms: 800 watts x 2 chan

2 ohms: 1300 watts x 2 chan

 

Package Including:

1 x Audio Power Amplifier

 

Note:

1.Please connect the battery positive,Don't just connect a positive line casually, or it will Burn out circuit.

2.The GND interface must be connected to the negative pole,ground connection is OK.

3.Be sure to connect the REM interface.when you test the amplifier,you can connect with power ground +12V.And then,you should find the ACC control wire interface which on your CD player, if the Player has no this interface,you can connect the ACC line that on the key switch.Make sure don't Press the iron, or it will short-circuit.

4.If you find the indicator light is red when you wiring,please unplug the power immediately and reconnect.If the red light lasts for five minutes,the protection of the amplifier will burn out.The blue light is normal.