Audio Speaker Frequency Divider Full Range with 2 Way Crossover Filters - 400W - Connection, Accessory

•Model: YLY - 2088​

•Frequency Point: Not pre - set; determined by debugging to suit specific audio requirements.​

•Power: 400W, capable of handling high - power audio systems.​

•Impedance: 4 - 16 ohms, compatible with a wide range of speakers.​

•Material: The inductor is wound with oxygen - free copper, with a pure copper wire diameter of 0.8mm. A super - large - capacity capacitor is used, and the overall design is reasonable, with an exquisite appearance for comprehensive sound quality control.​

•Size: 7x5x2.5cm/2.75x1.96x0.98inch​

•Weight: 75g​

•High and Low Split Frequency Wiring​

•Input: Connect to the power source or the rear junction box. This is the starting point for the audio signal to enter the frequency divider.​

•TREBLE: Connect to a tweeter. The frequency divider will direct the high - frequency audio signals to the tweeter for clear and crisp high - end sound.​

•BASS: Connect to the bass speaker. The low - frequency audio signals will be sent to the bass speaker for a powerful and deep bass output.​

•Wiring Base Twisting Operation​

•Use a small slotted screwdriver to loosen the compression plate in a counter - clockwise direction.​

•Slide the compression plate down, peel the wire, and insert it into the appropriate slot.​

•Tighten the compression plate in a clockwise direction to secure the wire in place.​

•Full Frequency Coaxial Connection Method​

•Connect the speaker to the BASS/bass position on the frequency divider.​

•Then, find a small wire and connect it from the positive pole of the bass to the positive pole of the tweeter. This allows for a proper connection in full - frequency coaxial setups.​

•The manual tightening force should be stronger than the fixed feet of the wiring base to avoid deformation. When tightening, use your fingers to firmly pinch the wiring base.​

•In case the compression plate cannot be tightened due to being too loose, turn the frequency divider upside down, screw in the compression plate, and then return to the wiring process. This will ensure a secure and proper connection.​