TEC1-12706 Thermoelectric Cooler Peltier 12V 4.5A Cells Peltier Elemente Electronic Cooling

 

COD: The our shop products are supported by cash on delivery;

 

Shipment: Order will be shipped out within 24hrs from Manila;

 

Delivery: 2 days to arrive NCR and 2-5 days to other provinces;

 

Courier: J&T Express.

 

Warranty: 6 months warranty

 

Matters needing attention:

*The working state of the refrigeration chip is to cool while heating. During operation, the heating surface must be well cooled, and it is strictly prohibited to power on for more than 2 seconds without heat dissipation, which may cause overheating and burning. The buyer shall bear the responsibility!

*When installing a radiator, it is necessary to apply thermal grease.

*Some have a literal meaning of cold noodles, while others have a literal meaning of hot noodles.

*The temperature difference between the hot and cold sides is 68 degrees (as long as the temperature of the hot side remains below 68 degrees, the temperature of the cold side can be controlled between 0 and -68 degrees or lower)

*When connected to a 12V power supply, there will be a temperature difference between the two sides of the refrigeration unit. One side is cold and the other is hot. Do not power on the refrigeration unit for a long time without a radiator, otherwise it will cause internal overheating and burnout of the refrigeration unit.

*This product can be applied to various cooling scenarios (such as hot and cold water dispensers, computer CPUs, graphics card cooling, etc.)It can also be applied to other purposes and fields such as electronic refrigerators, electronic cooling headbands, electronic cooling helmets, electronic hot and cold cups, etc. It is used for computer heat dissipation. A voltage of 5 volts is sufficient, which means that any red or black wire in the power cord of the computer is 5 volts, with the red wire being the positive pole and the black wire being the negative pole (the cooling plate is also like red positive and black negative)

 

Installation and use:

Before installation, it is best to prepare some thermal conductive silicone grease. Then, find a dry battery and connect it to the two leads of the refrigerator. You can feel that one end is noticeably cold while the other end is hot. Remember the polarity of the leads and determine the cold and hot ends of the refrigerator. If you want to achieve a larger cooling capacity, it is recommended to use a two-stage cooling method, which involves stacking two pieces together, with the cooling surface of the upper piece absorbing the heat generated by the lower piece. Experimental results have shown that two-stage cooling is much better than single-stage cooling. If conditions permit, a three-stage cooling can be chosen, of course, with the support of a high-power power supply.

 

Package Included:

1*thermoelectric cooler

 

__________🚗After sales service___________

 

Thanks for ordering from us.