300-500mm Digital Linear Displacement Sensor Scale Injection Molding Machine Pull Rod Measure Resistance

Application scope of tie rod electronic ruler: suitable for position detection of various types of equipment, such as injection moulding machine, die casting machine, rubber machine, shoe machine, EVA injection moulding machine, hollow bottle blowing machine, woodworking machinery, hydraulic press, etc.

usually powered by 5V and 10V power supply, outputs 0-5V and 0-10V voltage

signals; Or 12-24V power supply, output 0-5V, 0-10V, 4-20mA analog signals and

RS485 digital signals through internal or external transmission modules. Side

outgoing line, shielded wire standard configuration is 1m. If you have special

requirements, please contact us to explain

The installation instructions and the

selection of linear displacement sensor range need to leave margin. It is

recommended to select a slightly larger range based on the actual travel. When

installing the sensor, it is advisable to leave the allowance evenly at both

ends, and then lock the bracket screws after the position is adjusted. 2. The

two ends of KP twisted linear displacement sensor are twisted and fixed, and

there is no special requirement for installation to neutral. 3. The length of

the linear displacement sensor is connected to the circuit as a voltage divider

to display the actual value of the measured position with relative voltage. The

sensor power supply voltage should be stable, and the industrial power supply

requires ± 0.1% stability, otherwise the measured data will fluctuate greatly

The power supply should have sufficient capacity. If the power supply capacity

is too small, it is easy to cause the display data to jump, especially when the

solenoid valve drive power supply and the sensor power supply are together, the

digital jump is more likely to occur. 6. There shall be no external

interference, including electrostatic interference and high-frequency

interference. Therefore, the sensor signal line should be routed with the

equipment power line in separate slots; The sensor shall be installed with a

forced grounding bracket, and the sensor housing shall be well grounded; The

shielded wire shall be used for the signal wire, and the shielded wire shall be

grounded or connected to the negative pole of the DC power supply at one end of

the electric box. 7. The sensor should be wired correctly. If the wiring is

wrong, the sensor may be seriously damaged. 8. For sensors used for a long

time, the contact resistance of the brush will be affected due to the invasion

of water, oil, dust, etc., which will cause the measured data of the sensor to

Delivery conditions

Livraison gratuite, nous choisissons une société de logistique relativement rapide! Vers les états-unis, l'ue, l'asie et d'autres pays.

Le délai de livraison est d'environ 7-35 jours.

When you pay additional shipping fees, DHL, UPS, FedEx, and EMS are also available. The delivery time is about 3-7 days.

After sending, we will provide you with a tracking number.

Commentaires

If you have any questions about transportation, products, or services, please contact us before raising a dispute or leaving negative feedback.

Thank you for the 5star positive feedback on the description, transportation, and service.

When you send a screenshot of positive feedback, we will offer a discount for your next order.

customer service

If you have any questions, please contact our customer service first.

Generally speaking, we will reply to your message within 24 hours.

Like the time difference, the response will be delayed by about 6 to 10 hours.

Politique de retour

If the product has defects or does not meet the description, we can return or refund it.

We only handle the shipping cost of defective products returned.

If the return is due to your personal reasons, the return shipping fee will be paid by you.