Product description
•1, the optimum operating temperature should be between 18-32 degrees.
•2, the product can be used directly as needed openings evenly coated in sticky surface.
•3, wait 3-6 minutes, the two are aligned adhesive sticky little pressure.
•4, put a few hours straight, 48 hours after the optimum adhesive strength.
Appearance: transparent semi-fluid
Hardness after curing: 70-85A
Surface dry time: 3 minutes or so
Full cure time: 24-48 hours
Save: Save at 10 to 28 degrees
1. Please read the product description carefully before use.
2. Before using in large area, please do a small area experiment first;
3. Please ensure that the surface of the adherend is clean and dry;
4, the use temperature should be between 18-32 degrees;
5. The product can be directly coated on the surface of the adherend as needed;
6. Wait for 1-2 minutes, align the two adherends with a slight pressure;
7. It can be put in a few hours, and the ideal bonding strength can be achieved after 48 hours.
8. When the product is not in use, cover the bottle to avoid curing after the glue contacts the air.
Factory direct sales, if you need a lot of wholesale, you can contact the owner directly
Due to the color temperature of the monitor, camera, ambient light, and photography techniques, some products may have a slight color difference, and the color is subject to the actual product!
For buyers who are very sensitive to chromatic aberration, please contact the store and communicate with the store. The color difference problem cannot be used as a reason for the bad review and complaint.
I like to pay attention to the price of MM, the price of the store is very low, and there is no bargaining space, please also kiss the mouth, do not waste time.
After the product is photographed, please pay within 48 hours. In case of special circumstances, please contact the store in advance. If there is no explanation, the goods will not be reserved, and the photo will not be bought!
Before shipment, we will carry out strict quality inspection on the products (do not send the defective products), there should be no quality problems, but occasionally there will be small defects in the production process, these are not quality problems, the pursuit of perfection Please take caution with your parents.