•Preparation:Gather necessary tools, such as screwdrivers and pliers.Ensure the motorcycle is turned off and the battery is disconnected to prevent electrical shock.
•Locate the Relay:Identify the location of the existing relay on your motorcycle, usually found near the battery or under the seat.Remove any covers or panels to access the relay.
•Remove the Old Relay:Disconnect the wiring from the old relay, noting the connection points for accurate reinstallation.Remove the old relay from its mounting bracket or location.
•Install the Shinagawa Relay:Connect the wiring to the new Shinagawa interrupter relay, ensuring each wire is connected to the correct terminal.Secure the relay in place using the mounting bracket or location where the old relay was installed.
•Adjust the Settings:Use the adjustable feature to set the desired flash rate or timing for your motorcycle's turn signals or other intermittent systems.Refer to the instructions for guidance on adjusting the settings.
•Testing:Reconnect the motorcycle battery and turn on the ignition.Test the turn signals, hazard lights, or other systems controlled by the relay to ensure they function correctly.Adjust the settings further if necessary to achieve the desired performance.
•Final Checks:Secure any loose wiring and ensure all connections are properly insulated.Replace any covers or panels removed during the installation process.