NanoVNA-H Vector Analyzer 10KHz-1.5GHz with SD Card Support

1. This spectrum analyzer supports typec-typec cable, which is more convenient to connect to phones, and supports most Android phones with the same screen display (iPhone is not supported). Solve problems such as small screen and insufficient brightness.

2. Support domain analysis function (TDR)

3. The interface can display the usage.

Function:

1. Lower noise, less noise when using harmonics;

2. Built-in 400mAh

3. Add a MicroSD card to save the test data;

4. Add RTC support;

5. Modify the port names to Port1 and Port2

MicroSD supports up to 32GB, and only supports SPI mode.

Specification:

: 54mm x 85.5mm x 11mm (without connectors, switches)

● Measurement frequency: 50KHz ~ 1.5GHz

● RF output: -13dbm (maximum -9dbm)

● Frequency accuracy:

● Frequency stability:

● Measurement range: ● Measurement range: 70dB(50kHz-300MHz),(50dB(300M-900MHz), 40dB(900M-1500MHz));

● Port SWR: < 1.1

● Display: 2.8 inch TFT (320 x240)

● USB Interface: USB type-C Communication Mode: CDC (Serial)

● : USB 5V 120mA, built-in 400mAh , maximum charging current 1A, can be continuously for more than 4 hours

● Number of calibration points: 101 (fixed)

● Number of scan points: 101 (fixed)

● Display Tracks: 4, Markers: 4, Settings Save: 5

The package includes:

1. NanoVNA host*1 (including 2.8-inch touch screen, 400mAh )

2. 20cm SMA male to male RG174 RF cable *2

3. SMA female to female connector *1

4. SMA Calibration Kit SHORT *1

5. SMA Calibration Kit OPEN *1

6. SMA Calibration Kit LOAD *1

7. USB Type-C data cable *1

8. Touch pen*1

9. Picks

:

1. Due to various factors such as the brightness of the display and the brightness of the light, the actual color of the item may be slightly different from the picture displayed on the website.

2. Please allow slight manual measurement deviation in the data.

The package includes:

1. NanoVNA host*1 (including 2.8-inch touch screen, 400mAh )

2. 20cm SMA male to male RG174 RF cable *2

3. SMA female to female connector *1

4. SMA Calibration Kit SHORT *1

5. SMA Calibration Kit OPEN *1

6. SMA Calibration Kit LOAD *1

7. USB Type-C data cable *1

8. Touch pen*1