WAVLINK N300 PISO WIFI Voucher Outdoor Access Point with Active PoE Powered, WAN/LAN Port, Waterproof, Outdoor Wireless Extender Long Range with AP/Router/Repeater Modes 2x7 dBi Directional Antennas

*IP67 Rated Weatherproof Case: The IP67-rated weatherproof and heat-resistant enclosure ensures continued operation in harsh outdoor environments, including extremely cold, hot or constantly humid climates. It can withstand a wide range of humidity and temperature (-10°C to 50°C, and has 15KV ESD and 6KV lightning protection.

PISO Wifi in the Philippines:

Users insert one Philippine Peso coin for internet access.

Connect to the network after inserting the coin.

Disconnect and retrieve coin after usage.

Advantages:

Affordable internet access for just one peso.

Conveniently located in public areas.

Flexible usage based on inserted coins.

Widely available across the country.

*Multiple Working Modes: It supports four working modes. The repeater mode extends the Wi-Fi coverage of an existing wireless network. Router mode creates an instant private wireless network, enabling multiple devices to share it. AP mode converts a wired network to a wireless one. AP+Repeater mode extends the range of a wireless network by using a repeater to amplify and relay the signal from an access point.

*Outdoor Access Point: It has a maximum coverage range of 150 meters, supports up to 32 devices, and provides 2.4GHz, 300Mbps, high-speed, and 100M Ethernet ports. Simple settings enable wireless optimization to improve the quality and effectiveness of link transmission. (Coverage may vary based on the actual environment.)

*Single-Band Range Extender: Powered by 802.11n Wi-Fi technology, you can enhance your existing wireless coverage even in single-band range, providing speeds of up to 300Mbps on the 2.4GHz band. This allows you to enjoy high-speed downloading of your games, videos, and other files even in public areas.

WAVLINK 300Mbps Outdoor Access Point

The WAVLINK Wi-Fi AP/Repeater/Extender is mainly used for providing free Wi-Fi service in large areas such as factories, communities, streets, etc. The AP/Repeater/Extender can take an existing 2.4GHz wireless signal, repeat it, and extend it to a longer range where it is too far away for the router or access point to reach. And it can support 2.4G transmission speeds of up to 300 Mbps. It has two external antennas, providing even better wireless performance, transmission rates, and stability. Automatically avoids channel conflicts using its channel selection feature.

Applicable to Kinds of Weather

IP67-rated weatherproof and heat-resistant housing ensures continued operation in harsh outdoor environments. For example, it is sunny and exposed to the sun; it rains and is wet; it snows and freezes; and there is thunder and lightning.

Applicable to Multiple Scenarios

It is suitable for various large-scale outdoor scenes, whether it is your own yard, outdoor swimming pool, school, park, playground, or outdoor parking lot.

Waterproof Case Design

The waterproof housing has an IP67 rating for impressive dust and water resistance, allowing it to operate reliably even when exposed to harsh outdoor conditions or temporary rain.

7dBi Omni Directional Antenna

The high-gain antenna panel has two built-in 7-dBi omni directional antennas, which are designed to strengthen the WiFi signal in one direction and make it more concentrated. And WiFi coverage in a specific direction is farther than omnidirectional antennas.

Default Parameters

2.4G SSID: WAVLINK-N XXXX

Default IP: 192.168.10.1

Default Password: admin

How to Install Antennas and Ethernet Cable?

1) Pass the RJ45 cable through the spiral cover.

2) Pass the RJ45 cable through the rubber seal.

3) Pass the RJ45 cable through the holder.

4) Connect the RJ45 cable to the RJ45 port.

5) Spin the 2.4G antenna into the 2.4G external RP-SMA connector.

6) Tighten to secure the holder.

7) Insert the rubber seal into the holder.

8) Secure the spiral cover by screwing it on.

Note: The PoE converter is not waterproof, please install it indoors. Please make sure your Ethernet cable is CAT5E or above certified and shorter than 100m/328ft.

Installation Steps for the Device

1) Fasten the main body holder.

2) Plug the device into the holder.

3) Connect one end of an Ethernet cable to the "PoE" port of the PoE converter.

4) Connect one end of another Ethernet cable to the "LAN DATA IN" port of the PoE converter, and connect the other end to a "LAN" port of your router.

5) Plug the Power Adapter into the power outlet.

6) Push the "ON/OFF" button on the PoE converter to power on.

Warm Tips

1.The PoE converter is not waterproof, please install it indoors.

2.Please make sure your Ethernet cable to the outdoor router is CAT5E or above certified and shorter than 100m/328ft.

3.Please install the product 2-3 meters above the ground for better performance.

Specification

1.Model: WL-WN570HN2-B

2.Ports: 1 x WAN/LAN 100Mbps

3.Button: 1 x Reset(8s); Status LED: 1 x Power, 1xWAN/LAN, 1 x WiFi , 3 x Signal

4.Power Supply: DC 54V/0.3A Power over Ethernet(Passive), DC 48V Power over Ethernet(Active)

5.Wireless Standard: IEEE 802.11 b/g/n

6.Frequency Band/Speed: 2.4GHz(300Mbps)

7.Antenna: 2 x 7dBi Omni Directional Antennas

8.Wireless Security: WPA-PSK/WPA2-PSK encryption

9.Unit Size(without antennas): 18cm x 5cm x 5cm (L x W x H ); Antenna Length: 25cm

10.Ethernet Cable Length: 100cm

11.Power Adapter Cable Length: 120cm

12.Operating Temperature: -10°C~50°C

13.Storage Temperature: -30°C~70°C

14.Distance:Outdoor 150m(Change with the Actual Environment)

Features

- Easy installation, flexible placement

- Supports AP, Router, Range Extender and AP+Repeater modes

- Robust weatherproof enclosure design, 15KV ESD and 6KV Lightning Protection

- Complies with IEEE 802.11 b/g/n standards, wireless speed up to 300Mbps

- 2x 7dBi high-gain antennas

- Supports WPA/WPA2 (TKIP/AES) Encryption modes

- Features 6 LED status indicators

In the Box

1x N300 Outdoor Access Point

2x 7dBi High-gain Antennas

1x RJ-45 Ethernet Cable

1x Power Adapter

1x PoE Converter

1x Main Body Holder

2x Cable Ties

1x Screw Fitting Kit