1Pc/1Pair Neon Bike LED Lights Tire Valve Light Flash Auto Car Bicycle Motorcycle Tire Air Valve Wheel Spokes Light

100% new and high quality

Color: See picture

Size:A height 5.8cm/2.28in, B height 3.6cm/1.4in, C height 10.6cm/4.17in

Installation location: On the vehicle valve

Product model: dual-sensor type (light sensor, shock sensor)

Product material: lightweight alloy

Product line: independent circuit design, consisting of light control circuit, dynamic sensing circuit, and light-emitting circuit

Product power supply: 3 AG10 button batteries

Applicable models: cars, motorcycles, electric vehicles, and bicycles.

Package Includes:2Pair Valve Tire Light

The super cool and exquisite Hot Wheels is composed of dynamic induction circuit and light-emitting circuit. The LED light is always bright and has an independent circuit design, so there is no need to modify or connect the car's own circuit. Tighten it on the valve of the car or motorcycle tire. As long as the car is driving at night, it will emit a charming halo as the tire vibrates. It is also waterproof and is called hot wheels.

There is no need to modify or connect the circuit of the car body itself, just tighten it on the valve of the wheel of your car;

The color is cool blue light and seven-color light

Just screw on the tire valve core and you're done!

Must read before buying:

1. It will light up when the electronics are first installed, but will not light up after that!

2. At night or in low light conditions, it will light up only when it is shaken. It will light up for 15-20 seconds each time it vibrates, and it will not light up during the day!

3. This is a dual-sensor Hot Wheels. The so-called dual-sensor means light-sensitive and shock-sensitive. After all, it is just a simple photosensitive element. Friends who pursue perfection should be careful when shooting.

Installation precautions and solutions to common problems:

1: Hot Wheels uses three AG10 batteries (included). When installing, please correctly align the positive and negative poles, with the unmarked end facing the spring.

2: Be sure to put the battery into the black insulating leather case inside and do not expose it. Otherwise, the metal short circuit between the battery and the lamp housing will cause the battery to discharge and heat up, and it will run out of power in a few minutes.

3: Be careful when twisting the lamp holder, and make sure that the metal strip in the gap on the edge of the lamp holder is in good contact with the metal base (if the metal is too close to the inside, you can manually pull it out a little, but it must be gentle!)

4: If Hot Wheels does not light up under normal conditions, you can adjust the length of the spring to ensure full contact with the battery (do not use too much force, which may easily cause the spring to fall off). If it still does not light up, proceed to step 3.

Note:

1. Please allow 5-10mm differences due to manual measurement, thanks.