Electriq Multi Tester Samwa YX-360TRn Multi Meter Multitester Analog

•Specification

•Model: YX-360TRn

•Sanwa YX-360TRn Electrical Multi Tester/Multitester

•With Free one Pair Test Pen.

•Plug the test leads into COM and + sockets.

•Place the range selector in a prescribed range position.

•Short the test leads and turn 0A DJ to set the poin-ter to zero position.

•Make sure that there is no voltage across the circuit to be tested.

•Connect the test leads to the tested resistor and read the scale in accordance with the reference table.

•CONTINUITY TEST (BUZZ) Set the range selector knob to BUZZ, apply the test lead pins to two points to be tested and test continuity. Then the buzzer will buzz at between 0 and about 120. It is impossible to test a point where voltage is being applied.

•CONTINUITY TEST (LED). Set the range selector to the"CONT'Y" position. Connect the test leads to the tested circuit if the"LED" in the tester produces light which means the tested circuit is continuous.

•Note : No Batteries included