Electric Shaver 3 in 1 Shaver for Men shaving Beard Hair Trimmer Nose Hair Clipper Razor

Correct use and maintenance of electric razor, not only can achieve satisfactory shaving effect, but also can extend the service life of electric razor. Use should pay attention to the following aspects.1, the installation of the power supply should pay attention to the polarity of the dry battery or charger to prevent the motor reversal, thus damaging the fixed blade and dynamic blade.2, shaving, the fixed blade should be close to the face slowly push, to move against the direction of the growth of the beard, so that the beard smoothly into the net hole. If you move with the beard, it will overwhelm the beard, which is not conducive to the beard into the mesh.3, electric shaver should not shave long beard, so every 4 days or so shave a good. If the beard is very long, you should first use push shears or small scissors to cut the beard short, and then shave with an electric razor. If there is no push shears or small scissors, then you should use multiple times to split shaving method, first the fixed blade (mesh) and the beard into a vertical direction to touch the skin, shave the beard short some, and then according to the method of 2.4, with the push shear of the electric razor in use, should push the blade of the shear and face to maintain a vertical angle to push, in order to shave the beard.5, shaving once the phenomenon of stop rolling, the power should be turned off and restarted, to continue shaving after the motor rotation normal.6, electric shaver fixed blade is very thin, not forcibly pressurized to make it deformed or damaged.7, dry battery type electric shaver, after use or long-term shelving should be removed from the battery to avoid moisture leakage of the battery, causing unnecessary corrosion damage. AC electric shaver, after using the power should be cut off, pull out the plug to ensure safety. Rechargeable electric shaver can not make the power discharge too much, if the battery is insufficient should be charged first and then use, if long-term shelving without, should also be charged regularly (about three months).8, to regularly add a small amount of lubricant to the bearing parts to reduce wear and tear. Non-wet electric razor, do not use water or alcohol and other volatile chemicals to clean. Non-stainless steel material blade, if not used for a long time, should be wiped on the blade layer of thin oil to prevent rust damage to the blade.9, after each use of the razor, the application of small brushes to sweep away the dirt such as hair, shall not let the dirt set, otherwise there will be a motor jam or transmission blocked phenomenon. At the same time shavings and skin grease once cured on the blade, will affect the sharpness of the blade.