3HP Grinder Wet and Dry Grinder Corn Grinder Rice Grinder Coffee Grinder Peanut Grinder 2200w

New Portable Grinder (for wet and dry mills) Aluminum head to prevent rust (rice, coffee beans, corn, peanuts) Voltage: 220V 50-60Hz Motor power: 2.2 Kw Motor speed: 1400 r/min. Production particle size: 25-100 mesh Size: 65x25.5x74.5cm Weight: 30Kg Motor: copper core Dear customer, if you need multiple products, you can chat with customer service privately 150 steel mill model: powder 70kg/h slurry 60kg/h Instructions for use: Wet and dry use. Suitable for grinding soy milk and tofu, small tofu, wet rice milk, glutinous rice flour, etc. A small amount can be dry ground, and more powder can be coke. Household power supply is 220v; raw material block is less than 2cm; friction, friction sound like commercial vacuum cleaner; pulverizer is not a precision instrument and will leak powder and water near the head and shaft. The ratio to water is ready to use. It can be connected to a water pipe, but cannot make high-concentration slurry; edible oil or water is added to the sesame paste; the sand mill is a pollution-free high-pressure plate, and a little sand will fall off when it is started. Rice and water test for half an hour. The induction motor is allowed to exist, and it is within the normal range at 36v; the thickness valve needs to be adjusted when the card machine is turned on, otherwise the coil will be burned; overloading of the motor is prohibited, and work for 1 to 2 hours rests. Operation Notes: In the case of power failure, the blanking iron sheets are all closed, the thickness adjustment handwheel and the locking handwheel are all released to the left, and the hopper is full. Turn on the power, slowly open the blanking iron, and slowly adjust the thickness effect to the right. Refining, in the process of processing, if the machine is stuck, you should cut off the power supply at the first time, clean it up, and operate it again. (In the case of a jamming machine, the general situation is that the adjustment handwheel is too tight and the blanking iron sheet is too open) 150 Precautions 1. The motor shall not be flooded. If the head needs to be cleaned, it is recomme Usage: After all the adjusting valves and triangular screws are opened, all the blanking iron plates of the machine are locked. After power on and idling, open one third of the blanking iron plates, and slowly adjust them one by one. It cannot be adjusted to the end at one time. Then adjust them to the desired effect, and locking the triangular screws is complete.